Toro 624 Snow Blower Category

Original Model: Tecumseh H60

This engine has a 1" diameter shaft on it. Please note the newer engines have a thicker mounting base so you may need to use longer mounting bolts. If you have mounting studs they may need to be taken off and replaced. If you use the engine with a sleeve, PLEASE NOTE that if your key stock is built into your pulley, this sleeve will not work for you.

Parts List

6 Products

Bush-.75x1x.50

, Bronze bushing, 3/4" ID, 1" OD, .5" Long, Unbranded

$12.45

In Stock:3

Bush-.75x1x3

Sleeve-.75x1x3, Bronze bushing, 3/4" ID, 1" OD, 3" Long, Unbranded

$12.45

In Stock:42

Bush-.75x1x3-Key

Sleeve-.75x1x3-Key, Bronze bushing, 3/4" ID, 1" OD, 3" Long, 1/4" key way, Unbranded

$12.45

In Stock:6

Shaft key

KeyStk-T-.188x.25x2.20

Stepped key stock from 3/16" to 1/4" x 2.20" long, Unbranded

$8.95

In Stock:61

KeyStk-T-.188x.25x2.20X.344

Stepped key stock from 3/16" to 1/4" x 2.20" long x .344" overall height, Unbranded

$19.95

In Stock:20

Sleeve-34-1x220-Key

, 2.20" Long, to go from 3/4" shaft to 1" shaft including a stepped key from 3/16" to 1/4", Unbranded

$20.99

In Stock:4

Questions? Email us directly:

Required Fields *

General Disclaimer

While we may have sold many engines listed above to be used for a Toro 624 Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.