Ariens 924048 Snow Blower Category

Original Model: Tecumseh is H70 130210f

The models with a H50-H60-H70 engines on them typically have a 1"x2-3/8" shaft on them. The Briggs Intek OHV 5-7.75hp engines will normally replace these engines.

Additional Info
If you buy an engine with a 3/4" shaft, you will have to change your pulleys or purchase the sleeve kit to take the diameter from 3/4" to 1". You will need to replace the mounting studs with normal bolts for mounting. If your chute control rod goes above the engine, you will have to buy the same series of engine or modify it so the crank is out of the way.

Parts List

4 Products

Bush-.75x1x.50

, Bronze bushing, 3/4" ID, 1" OD, .5" Long, Unbranded

$12.45

In Stock:3

Bush-.75x1x3

Sleeve-.75x1x3, Bronze bushing, 3/4" ID, 1" OD, 3" Long, Unbranded

$12.45

In Stock:42

Bush-.75x1x3-Key

Sleeve-.75x1x3-Key, Bronze bushing, 3/4" ID, 1" OD, 3" Long, 1/4" key way, Unbranded

$12.45

In Stock:6

Sleeve-34-1x220-Key

, 2.20" Long, to go from 3/4" shaft to 1" shaft including a stepped key from 3/16" to 1/4", Unbranded

$20.99

In Stock:6

Questions? Email us directly:

Required Fields *

General Disclaimer

While we may have sold many engines listed above to be used for a Ariens 924048 Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.